| Show list | Next article |
XTREME PRO HIGH TACK BLACK (1PC)
Article in the following categories
solvent-free mounting adhesive with very high asset adhesion and very fast strength structure based on SMP polymer. Particularly suitable for heavy materials.
application area;
for gluing and assembling many building materials on almost all surfaces, such as wood, (nature) stone, (gas) concrete, metal, hard foam and various Plastics.
Suitable for indoor and outdoor applications, such as panels, ceiling elements, booids, drywall, plate and insulation materials, mirrors, control, baseboards and scraps.
For all professional applications, such as facade and interior construction, home, utility and bodywork building. Not suitable for PE, PP, PTFE, pure plaster, and bitumen. Always perform a suture test when bonding plastic. The adhesion on plastic can range varias, depending on the type of plastic and the quality of the plastic.
Properties;
· Very high asset adhesion
· Very fast strength building
· Permanent elastic
· Very good filling power
· Good stand power
· shrink free; 100% glue
· solvent free
· No edge zone contamination
· Weatherproof
· Temperature resistant from -40 ° C to + 100 ° C
· Paintable
· Covering approx. 2 mm / 24 hours
Preparation;
Processing conditions: The temperature of environment, the glue and the materials to be glued must not be lower than + 5 ° C.
Pre-treatment surfaces: parts must be clean, dust and grease-free. Ensure a sturdy surface. Substrate may be light-moist.
Using primer does not need.
Consumption: from 1 tube arrives approx. 7-9 meter glue.
Operating instructions:
Process only with special supplied nozzle. Cut thread and mount nozzle. Glue evenly, depending on the gravity of the material, to apply the 10 to 40 cm in vertical stripes or dots. Always apply glue to corner points and along edges. Material action (façade panels) can be collected by glue thickness of 3 mm (use distance cubes or tape). Mounting materials directly with a sliding motion and press firmly or beat. Correcting is still possible. Immediately close sleeve after use.
Stains / remains:
Wet glue residues remove immediately with turpentine. Dried glue residues can only be removed mechanically.
Points of attention:
The drying times below are based on the bonding of minimal & eacute; & Eacute; n porous material and a glue layer with a thickness of approx. 1 mm. In the bonding of two non-porous materials and / or a thicker glue layer, considerably longer drying times must be taken into account.
Dry times;
Skin forming time: approx. 10-15 minutes
Hand-trimmed time: approx. 30 minutes. This can be Vari & Euml; run depending on the circumstances, such as temperature and humidity.
Covering speed: approx. 2 mm / 24 hours
Dry / curing time: approx. 4 hours. This can be Vari & Euml; run depending on the circumstances such as temperature and humidity.